KUKA 00-128-506 KPC2004 Hard Drive for KRC2

KUKA 00-128-506 — KPC2004 Shock-Protected Hard Drive for KRC2 Controllers

The KUKA 00-128-506 is a KPC2004 shock-protected hard drive (KUKA controller accessory). It is the system and data storage drive that sits in a KUKA KRC2 control cabinet, holding the controller system software, robot programs and configuration data that the KRC2 needs to boot and run.

Specifications

Industrial Applications

• Stores and boots the system software on KUKA KRC2 welding, handling, palletizing and general automation cells.
• Restores a KRC2 controller after a failed or corrupted drive prevents the cabinet from booting.
• Keeps legacy KRC2 installations running without a full controller overhaul.
• Suitable as a spare or preventive-replacement drive for KUKA KRC2 robot lines.

Design Purpose

The KPC2004 hard drive is the data foundation of a KUKA KRC2 controller. It holds the KSS system software, the robot programs and the configuration that the controller loads on start-up, and it is built shock-protected to survive the vibration and duty of an industrial cabinet. When the drive develops bad sectors or corruption, the controller may fail to boot or lose programs — swapping the failed drive on the same controller generation restores operation without replacing the whole cabinet. The correct drive image and KRC2 version must match the cabinet when a replacement is sourced.

Common Failure Modes

• Bad sectors or a corrupted file system, causing boot errors or lost robot programs.
• Controller fails to start, where the KRC2 will not boot from the drive.
• Data loss after a power event, surge or unscheduled shutdown.
• Mechanical failure from years of cabinet vibration and heat.
• Verify by part number 00-128-506 and the controller type — send us your KRC2 controller label or current drive details and we confirm the correct drive and image before you order.

Why Choose Us

• Original KUKA 00-128-506 KPC2004 shock-protected hard drive, verified by part number.
• Controller type (KRC2) and drive image / software version confirmed before quotation.
• Supplied new or used original; condition confirmed before ordering.
• Drive checked before packing.
• Request a quote with your part number and controller type — we confirm the match before you order.

Related Products

• KUKA 00-115-489 — KRC2 controller unit, the cabinet this hard drive mounts in.
• KUKA 00-115-115 — KPS 600/20 ESC power supply module for KRC2-era cabinets.
• KUKA 00-117-336 — DSE PCB board, the KRC2 drive control electronics.
• KUKA 00-109-835 — KRC2 zero-point calibrator for controller setup.
• KUKA 00-176-743 — controller cabinet cooling fan, protecting drives and boards from heat.